Trane VUVE Vertical Classroom Manual de Instalação descarregar pdf (Página 23)

Installation—Mechanical

UV-SVN03F-EN 23

2. Set the unit on the subbase and fasten with four, 3/8 in.

x 16 ft x 1 in. hex head cap screws and 3/8 in. lock

washers.

Note: Hex

screws and lock washers are provided by

the factory. They are located in a baggy and are

used to attach the base to the unit ventilator.

Pre-drilled slots in the subbase flange will line

up with the weld nuts in the bottom of the unit.

3. The bottom of the subbase has weld nuts in four slots.

Place the leveling le

gs in those slots and level the unit.

End Panels

When ordered as an option, end covers ship already

attached to the vertical unit ventilator. The following

section is for installing end covers purchased as an add-

on.

It is recommended end panels be installed on the unit

ventilator after all piping, wiring and accessory installation

is completed. To install the end panel:

1. Insert the four factory provided metal studs into the

four pre-mounted nuts on the inside of the panel.

2. Align each stud with the four pre-drilled holes on the

de of the unit.

3. Secure the panel to the unit by fastening wit

h the four

factory provided nuts.

4. Do not overtighten screws.

Figure 12. Subbase with leveling legs

NOTICE:

Equipment Damage!

Do not run units for any length of time without all

panels and filters properly installed. Failure to do so

could result in equipment failure.

2"- 6"

Unit Base

Subbase

For leveling legs

Weld

Nuts

UV-SVN03_.book Page 23 Thursday, January 24, 2013 5:27 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 110 111

Comentários a estes Manuais

Sem comentários

Trane VUVE Vertical Classroom Manual de Instalação Página 23

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos Trane VUVE Vertical Classroom