Trane Performance Air Handlers Manual de Instalação descarregar pdf (Página 18)

18 CAH-SVX01B-EN

Installation - Mechanical

TCP Model Assembly Instructions

If the model number on the nameplate begins with TCP, use the assembly instructions below. The

TCP base is constructed for specific installation requirements such as standard roof curbs,

structural support curbs, steel I-beam dunnage support, and pier mounting.

NOTICE

Roof Curb Structurally Sound

Check with curb manufacturer and job engineer to ensure the roof curb is structurally sufficient

to support the weight of the unit. The curb should be checked to ensure it is level and square.

Curb bowing, buckling, or sagging can lead to unit assembly and operation problems up to

complete failure.

TCP Standard Roof Curb

Figure 4. Standard roof curb The TCP unit exterior base channel is

constructed to overhang the roof curb. Unit

support is provide by a square tube channel

locate inside of exterior base channel. See

Figure 4. The standard curb should be designed

to properly support the unit’s weight without

bow and sized to fit within the perimeter base

channel.

For large units shipped in sections, see

additional requirements in “TCP Roof Curbs for

Large Units with Shipping Splits” on page 21.

Air handler

base structure

Roof curb

Insulation

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Sem comentários

Trane Performance Air Handlers Manual de Instalação Página 18